Finally a no drill and tap Weaver style scope mount for
the Single Six. This scope mount requires no drilling or
tapping of your frame. Handsome, lightweight and
durable. Blends beautifully with the lines of the Ruger
frame. Accepts all Weaver style rings and accessories.
Mount is 4-1/2" long and weighs 1.3 ounces.
Available in Matte Black or Matte Silver anodized finish.
Revolver shown not included.
This scope mount attaches to the rear sight elevation
adjusting screw hole. You first remove the single six
rear sight and replace it with our scope mount. Then
insert the supplied screw into the elevation adjusting
screw hole and tighten. In the front there is a set
screw, that gets adjusted down just until
it touches the top strap.*
* Over tightening of the set screw can cause point of
impact problems. It will cause the revolver
to hit low.
